This product integrates optical fiber splicing, splitting, and wiring. It can realize the cable direct or branchconnection. Connecting to the optical communication equipment, it suits for the users terminal access. Throughthe adapter installed in the box, the drop cable leads the signal out, and achieves optical fiber distribution; it alstapplies to the protective connection of cable and pigtail; in addition, optical cable can also be spliced with homecable after splitting, finally achieve the optical signal transmission.
1.Install the adapters earless in the rack.
2. Strip the cable, remove the outer and inner sheath,lose tube, clean and remove the filling paste in the cableleave 0.6-1.2m bare fiber and 30-50mm steel corepass the cable into the box through the inlet, fix it withhose clamp, fasten the re-enforced core
3.After put the bare fiber protection tube onthe stripped fiber, coil it around the windinplate; lead the fiber end into the front splicingslot from the rear end of the flip board
4.Fix the steel pipe PLC in its special slot on the backof the flip board, coil the output pigtails and connectthem to the adaptors; lead the incoming pigtail into thesplicing slot from the notches on both side of the flipboard, splice it with the incoming fiber
5.After splicing, cover the inner lid and fix itwith screw; then connect the outgoing cable withadaptors and fixed them with nylon tie. close thecover. lock it with wrench.
Fix the box at the desired position with the expansionscrew, the installation is completed. (pole mounting oraerial application, special hangers need to be selected,which is fixed through 4 holes in the middle)
Wall and pole mountable, or in acrial application
The adapter (earless SC) bracket is a two-in-oneindependent component that can be separately installed andremoved, and can be rotated by a certain angle, which Isvery convenient for operation and can adjust the bendingradius of the outgoing cable
e structural design of the bottom shell, the reversible flipboard and the inncr cover makes the incoming andoutgoing cable area, the fusion area, the cable storage areaform a closed and independent partition, which isconvenient for management and maintenance.
|Model||FDB0416A||Max capacity||24 cores|
|Dimension / mm||231*152*59||PLC Splitter||1X16|
|Cable entry||2 uncut cable ports entry and exit||Net weight||1.25kg|
|Cable exit||1mid span(Φ13.5mm)||Waterproof grade||IP65|
|Cable diameter||≤φ12mm||splice tray quantity||1pcs|
1.All box is individual packed, with all accessories.
2.Master box is 5layer corrugated carton, which can ship directly or packed by non-fumigation pallet reinforced with plastic film wrapped and plastic strip.
3.We can print your own logo or brand on the master box if quantity is good,or make your own design.
E-MAIL : firstname.lastname@example.org